NaviSys Technology - Your Location Partner
GNSS Smart Antenna Module / GN-5013, GM-5014
GN-5013 / GM-5014
Ultra-High Performance
GNSS Smart Antenna Module
Easy to use: built-in patch antenna & 6-pin wire to
Overview
board connector w/ pitch of 1.0mm
GN-5013/GM-5014 is an easy to use, ultra-high
Optional RTCM support with 8-pin connector
performance, low power GNSS smart antenna module
Optional support of I-PEX RF connector and w/o
with patch antenna for vehicle/handheld applications.
patch antenna
GN-5013/GM-5014 support multiple satellite positioning
Backup battery support for faster position fix
systems - GPS, GLONASS, Beidou, QZSS and SBAS.
Optional V_BAT pin support to replace backup
Based on our experienced design, GN-5013/GM-5014
battery
fully exhibits the excellent performance of MT3333 chip. It
Optional PWR_CTRL pin to disable GPS module
works in GNSS signal difficult environment, provides fast
Green LED for position fix indication
acquisitions and excellent tracking performance.
Fully EMI shielded
Industrial operating temperature range: -40 ~ 85℃
Applications
Notes
Positioning
1.
Some features need special firmware or
Timing (GPS clock, FEMTO cell, traffic lights etc)
command programmed by customer
DGPS (RTCM SC-104)
2.
MOQ-based customization is welcome.
Features
Technical Specifications
Multi-satellite positioning systems support
GPS/QZSS/GLONASS (GN-5013)
Receiver Performance Data
GPS/QZSS/Beidou (GM-5014)
Receiver Type
GNSS Chipset: MT3333
High performance: -165dBm tracking sensitivity
GPS/QZSS: L1 1575.42MHz
Low power: 29 mA at continuous tracking
GLONASS (GN-5013):
SBAS (WAAS, EGNOS, MSAS, GAGAN) support
L1OF 1598.0625 ~ 1605.375 MHz
BEIDOU (GM-5014):
Up to 3-day self-generated orbit predictions
B1 1561.098 MHz
AGPS - up to 30-day orbit predictions from server
Channels:
12 multi-tone active interference cancellers
Tracking: 33 /acquisition: 99
Indoor/outdoor multi-path detection & compensation
Horizontal
< 3.0m (Autonomous)
Up to 10Hz update rate1
Position
< 2.5m (WAAS)
Optional high accuracy 1PPS timing
NaviSys Technology Corp.
http://www.navisys.com.tw/
Tel : +886-3-5632598
Fax: +886-3-5632597
Sales contact: sales@navisys.com.tw
Technical support: service@navisys.com.tw
Address:2F, No.56, Park Ave. II, Science-Based Industrial Park, Hsinchu 300, Taiwan (R.O.C.)
1
NaviSys Technology - Your Location Partner
GNSS Smart Antenna Module / GN-5013, GM-5014
Accuracy
(50% 24hr static, -130dBm)
Storage temperature
-40 ~ 85℃except
Velocity
<0.1 m/s (speed, w/o SBAS)
battery: -40~60℃
Accuracy
<0.05 m/s (speed w/ SBAS)
Vibration
5Hz to 500Hz, 5g
(50%@30m/s)
Shock
Half sine 30g/11ms
Timing Accuracy
±10ns RMS (1PPS output)
Mechanical Data
Time To First Fix
Autonomous
Hot start
<1sec, average
Warm start
24sec, average
Cold start
28sec, average
Reacquisition
(50% -130dBm)
Sensitivity
-148dBm (acquisition)
(Autonomous)
-165dBm (tracking)
Update Rate+
Up to 10Hz, default 1Hz
Max. Altitude+
<18,000 m
Max. Velocity
<1,852 km/hr
Datum+
WGS-84(default)
Protocol
NMEA 0183 V4.1, MTK NMEA
Support+
4800/9600(default)/38400/115200bps
N,8,1(No parity, 8 data bits, 1 stop bit);
Default: GGA, GSA, RMC, VTG@1Hz,
GSV@1/5Hz, GLL, ZDA@0Hz
SBAS Support
WAAS, EGNOS, MSAS, GAGAN
Dynamics
<4g
+Please contact Navisys for any customization demand.
Electrical Data
Power Supply
3.3 ~ 5.5 V
6-pin Interface, pitch 1.0mm
Power Consumption
29mA/average tracking
Backup Battery
Nominal voltage: 3.0 V
TTL I/O
VIH: 2~3.15V, VIL: 0~0.8V
VOH: >2.1V, VOL< 0.72V
GN-5013R, GM-5014R:
Pin
Name
Function
I/O
Protocols
NMEA, MTK NMEA
1
GND
Ground
Input
2
VCC
Power supply
Input
3
TXD-TTL
TTL level serial data output
Output
Environmental Data
4
RX-RS232
RS232 level serial data input
Input
Operating temperature
-40 ~ 85℃ except
5
TX-RS232
RS232 level serial data output
Output
6
RXD-TTL
TTL level serial data input
Input
battery: -20~60℃
GN-5013P, GM-5014P:
NaviSys Technology Corp.
http://www.navisys.com.tw/
Tel : +886-3-5632598
Fax: +886-3-5632597
Sales contact: sales@navisys.com.tw
Technical support: service@navisys.com.tw
Address:2F, No.56, Park Ave. II, Science-Based Industrial Park, Hsinchu 300, Taiwan (R.O.C.)
2
NaviSys Technology - Your Location Partner
GNSS Smart Antenna Module / GN-5013, GM-5014
Pin
Name
Function
I/O
1
GND
Ground
Input
2
VCC
Power supply
Input
3
1PPS
Time Pulse Per Second
Output
4
RX-RS232
RS232 level serial data input
Input
5
TX-RS232
RS232 level serial data output
Output
6
PWR_CTL
Power control; floating or high: ON
Input
Low : OFF
Ordering Information
GN-5013X, GM-5014X
X=R
standard - patch: 25x25x4, 9600bps, N-8-1,
GGA, GSA, RMC, VTG@1Hz, GSV@1/5Hz
*This document is subject to change without notice.
NaviSys Technology Corp.
http://www.navisys.com.tw/
Tel : +886-3-5632598
Fax: +886-3-5632597
Sales contact: sales@navisys.com.tw
Technical support: service@navisys.com.tw
Address:2F, No.56, Park Ave. II, Science-Based Industrial Park, Hsinchu 300, Taiwan (R.O.C.)
3